Conditions For Setting DTC P0716

1997 Chevrolet Chevy Van G2500, Van Cargo Extended, 6.5 FSECTION Conditions For Setting DTC P0716

DTC will set under the following conditions:

  • DTCs P0121, P0122 or P0123 (throttle position sensor) are not present.
  • DTCs P0502 or P0503 (output shaft speed sensor) are not present.
  • DTC P0717 (input speed sensor signal) is not present.
  • DTCs P0751 or P0753 (1-2 shift solenoid) are not present.
  • Vehicle speed is more than 25 MPH.
  • Transmission is not in Park or Neutral.
  • Throttle position is more than 15 percent.
  • Engine is running at more than 375 RPM for more than 7 seconds.
  • Engine is not in fuel cut off mode.
  • Input speed varies by 1300 RPM for more than 5 seconds.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.