Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1997CHEVY VAN G2500, VAN CARGO EXTENDED, 6.5 FREPAIR AND DIAGNOSIS (SINGLE PAGE)STEERINGPOWER STEERINGPOWER RECIRCULATING BALL STEERING SYSTEMTORQUE SPECIFICATIONS
1997 Chevrolet Chevy Van G2500, Van Cargo Extended, 6.5 F
Torque Specifications
1997 Chevrolet Chevy Van G2500, Van Cargo Extended, 6.5 FSECTION Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Adjuster Plug Lock Nut | 78-81 (106-110) | |
| Idler Arm Mounting Bolts | 35 (47) | |
| Idler Arm-To-Relay Rod Nut | 66 (89) | |
| Intermediate Shaft-To-Stub Shaft Bolt | 46 (62) | |
| Pitman Arm-To-Relay Rod Nut | 66 (89) | |
| Pitman Arm-To-Steering Gear Nut | 184 (249) | |
| Pitman Shaft Adjuster Screw Lock Nut | 35 (47) | |
| Rack Piston End Plug | 110 (149) | |
| Shock Absorber-To-Relay Rod Nut | 45-46 (61-62) | |
| Side Cover Bolts | 45 (61) | |
| Steering Gear Mounting Bolts | 66 (89) | |
| Steering Pump Mounting Bolts | ||
| 4.3L, 5.0L, 5.7L & 7.4L Engine | 36 (49) | |
| 6.2L Diesel | 32 (43) | |
| Tie Rod Adjuster Clamp Nut | 14 (19) | |
| Tie Rod-To-Relay Rod Nut | 66 (89) | |
| Tie Rod-To-Steering Knuckle Nut | 46 (62) | |
| Union Fitting | 55 (75) | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.