Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1997CHEVY VAN G2500, VAN CARGO EXTENDED, 6.5 FREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEM - GASOLINE (G SERIES)DIAGNOSTIC TROUBLE CODES (DTCS)DTC C0081: STOPLIGHT SWITCH ALWAYS CLOSED OR SHORTEDDIAGNOSTIC PROCEDURES
1997 Chevrolet Chevy Van G2500, Van Cargo Extended, 6.5 F
Diagnostic Procedures
1997 Chevrolet Chevy Van G2500, Van Cargo Extended, 6.5 FSECTION Diagnostic Procedures
- Perform diagnostic system check. See DIAGNOSTIC SYSTEM CHECK . After performing diagnostic system check, go to next step.
- Turn ignition on. Using scan tool, select DATA LIST function. Check the status of the stoplight switch while applying and releasing brake pedal. If scan tool indicates switch is closed (pedal not applied) at all times, go to next step. If not, go to step 4).
- Turn ignition off. Disconnect stoplight switch connector. Turn ignition switch to RUN position. Using scan tool, check status of stoplight switch. If scan tool indicates switch is closed (pedal not applied), go to step 7). If not, go to step 8).
- If scan tool indicates that switch is open (pedal applied) at all times, go to next step. If not, go to step 7).
- Turn ignition off. Disconnect 10-pin EBCM harness connector. Turn ignition switch to RUN position. Using DVOM, check voltage between ground and terminal "C" of 10-pin EBCM harness connector. If voltage reading is greater than 10 volts, go to next step. If not, go to step 8).
- Turn ignition off. Reconnect all harness connectors. Turn ignition switch to RUN position. Select DATA LIST function on scan tool. Using scan tool, check status of stoplight switch while applying and releasing brake pedal. If scan tool indicates switch is open (pedal applied) at all times, go to step 9). If not, go to next step.
- Malfunction is intermittent. See DIAGNOSTIC AIDS. After performing necessary repairs, perform DIAGNOSTIC SYSTEM CHECK .
- Repair faulty stoplight switch or open in stoplight switch circuit between EBCM and stoplight switch. See WIRING DIAGRAM . After repairs, perform DIAGNOSTIC SYSTEM CHECK .
- Replace EBCM. After replacing EBCM, perform DIAGNOSTIC SYSTEM CHECK .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.