Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Section 93 (Instrument Panel (P Series)): Identification
General Motors produced the Cutaway and Vandura as both a "G" series and a "P" series. This article is for the "P" series and can be identified by a "P" in the 5th character of the VIN. For "G" series, see ANALOG INSTRUMENT PANELS - G SERIES VANS article.
| Division | Model |
|---|---|
| Chevrolet | Cutaway |
| Chevrolet | Forward Control |
| GMC | Forward Control |
| GMC | Vandura |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.