Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1997CHEVY EXPRESS G3500, VAN CARGO, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 71 (ENGINE CONTROLS - TESTS W/CODES - 5.0L)SELF-DIAGNOSTIC SYSTEMDIAGNOSTIC PROCEDURE
1997 Chevrolet Chevy Express G3500, Van Cargo, 6.5 F
Diagnostic Procedure
1997 Chevrolet Chevy Express G3500, Van Cargo, 6.5 FSECTION Diagnostic Procedure
WARNING: This page is about a different car, the 1998 GMC Savana, 1998 Chevrolet Chevy Van, and 1998 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
Diagnosis of computerized engine control system should be performed in following order:
- Ensure all engine systems not related to computer system are operating properly. DO NOT proceed with testing unless all other problems have been repaired. Powertrain On-Board Diagnostic (OBD) System Check must be performed before using specific DTC testing procedure. See POWERTRAIN ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK .
- If DTC(s) were displayed, determine whether codes are hard or intermittent trouble codes. Hard codes will cause MIL to illuminate continuously while engine is running. See HARD OR INTERMITTENT TROUBLE CODE DETERMINATION . For diagnosing hard codes, proceed to appropriate DTC test. For diagnosing intermittent codes, proceed to INTERMITTENTS in H - TESTS W/O CODES - 5.0L article.
- If no DTCs are present and a driveability problem exists, refer to SYMPTOMS in H - TESTS W/O CODES - 5.0L article. Doing so will help identify proper system or component to check in I - SYSTEM/COMPONENT TESTS - 5.0L article.
- After necessary repairs are made, clear DTCs, verify vehicle will enter closed loop operation and ensure DTC does not reset.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.