Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1997CHEVY EXPRESS G3500, VAN CARGO, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 65 (CRUISE CONTROL SYSTEM - DIESEL (P SERIES))ADJUSTMENTSBRAKE RELEASE SWITCH
1997 Chevrolet Chevy Express G3500, Van Cargo, 6.5 F
Brake Release Switch
1997 Chevrolet Chevy Express G3500, Van Cargo, 6.5 FSECTION Brake Release Switch
WARNING: This page is about a different car, the 1997 GMC Vandura, 1997 GMC Forward Control, 1997 Chevrolet Forward Control, and 1997 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Fully depress and hold brake pedal. Push switch through retainer and pedal bracket hole until fully seated. Clicking can be heard as switch is pushed into bracket.
- Pull pedal fully rearward against pedal stop until clicking stops. Release pedal. Pull pedal fully rearward again to ensure no clicking can be heard.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.