Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1997CHEVY EXPRESS G3500, VAN CARGO, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 63 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)REMOVAL & INSTALLATIONAIR BAG MODULEREMOVAL (DRIVER-SIDE)
1997 Chevrolet Chevy Express G3500, Van Cargo, 6.5 F
Removal (Driver-Side)
1997 Chevrolet Chevy Express G3500, Van Cargo, 6.5 FSECTION Removal (Driver-Side)
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 1996 GMC Vandura Special, 1996 GMC Vandura, 1996 GMC Savana Special, 1996 GMC Savana Camper Special, and 1996 GMC Savana. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, read air bag service precautions section. See SERVICE PRECAUTIONS . Disable air bag system. See DISABLING SYSTEM .
- Rotate steering wheel so that side of air bag module is at 12 o'clock position. Insert a screwdriver into one of the 4 holes on back of steering wheel. Pull screwdriver handle away from steering column to release leaf spring from notched pin. Do this in all 4 holes. See Fig 1 . Partially remove air bag module and disconnect driver-side air bag module connector, and CPA clip. Remove air bag module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.