Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSCHEVROLET1997CHEVY EXPRESS G3500, VAN CARGO, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 42 (ENGINE CONTROLS - TESTS W/CODES - 5.0L)TROUBLE CODE CHARTSCODE 36, IDLE SPEED ACTUATOR FAULT - A/TNOTES
1997 Chevrolet Chevy Express G3500, Van Cargo, 6.5 F
Code 36, Idle Speed Actuator Fault - A/T: Notes
1997 Chevrolet Chevy Express G3500, Van Cargo, 6.5 FSECTION Notes
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1995 GMC Vandura, 1995 GMC Rally, 1995 GMC Pickup, 1995 Chevrolet Sportvan, and 1995 Chevrolet Pickup. However, it is still accessible from the selected car via links, so may be relevant.
Control module grounds solenoid circuit when coolant temperature is within range to enable solenoid, allowing vacuum to retract solenoid actuator. This lowers idle speed to controlled IAC idle specification.
NOTE:
Test numbers refer to numbers on diagnostic chart.
- Checks if vacuum source is present.
- Checks to see if actuator is commanded on.
- Checks for power, ground and proper connections at actuator solenoid.
- Checks for open ground circuit.
- Checks for open driver circuit or faulty control module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.