Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1997CHEVY EXPRESS G3500, VAN CARGO, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 33 (ENGINE CONTROLS - TESTS W/CODES - 3.8L)TROUBLE CODE CHARTSCODE P0113, IAT SENSOR CIRCUIT HIGH INPUTDIAGNOSTIC AIDS
1997 Chevrolet Chevy Express G3500, Van Cargo, 6.5 F
Diagnostic Aids
1997 Chevrolet Chevy Express G3500, Van Cargo, 6.5 FSECTION Diagnostic Aids
WARNING: This page is about a different car, the 1995 Pontiac Trans Sport, 1995 Oldsmobile Silhouette, and 1995 Chevrolet Lumina APV. However, it is still accessible from the selected car via links, so may be relevant.
An intermittent may be caused by a poor connection, rubbed through wire insulation or a wire broken inside insulation. Check for:
- Poor Connection Or Damaged Harness
Inspect control module harness for short to ground in circuit, improper mating, broken locks, improperly formed or damaged terminals, poor terminal to wire connection, and damaged harness. - Intermittent Test
Observe IAT on Tech 1 while moving related connectors and wiring harness with warm engine running. If failure is induced, IAT display will change to a 297°F (147°C) temperature reading. This may assist in isolating location of malfunction.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.