Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1996TAHOE 2D UTILITY, 6.5 SREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - BASIC DIAGNOSTIC PROCEDURES - DIESELBASIC FUEL SYSTEM CHECKSFUEL PUMP FLOW TEST
1996 Chevrolet Tahoe 2D Utility, 6.5 S
Fuel Pump Flow Test
1996 Chevrolet Tahoe 2D Utility, 6.5 SSECTION Fuel Pump Flow Test
- Disconnect fuel line at fuel filter inlet. Disconnect fuel injection pump electric shut-off solenoid wire (Pink).
- Crank engine for 15 seconds. If fuel pump does not supply about 1/2 pint of fuel in 15 seconds, go to FUEL SYSTEM PRESSURE TEST .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.