Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1996TAHOE 2D UTILITY, 6.5 SREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEMIRRORSPOWER MIRROR SYSTEMSYSTEM TESTINGBOTH POWER MIRRORS DO NOT OPERATE
1996 Chevrolet Tahoe 2D Utility, 6.5 S
Both Power Mirrors Do Not Operate
1996 Chevrolet Tahoe 2D Utility, 6.5 SSECTION Both Power Mirrors Do Not Operate
- Disconnect power mirror switch connector. Connect test light between power mirror switch harness terminal "H" (Orange wire) and ground. If test light glows, go to next step. If test light does not glow, repair open in Orange wire from power mirror switch connector to fuse block.
- Connect test light between power mirror switch harness terminals "H" (Orange wire) and "A" (Black wire). If test light does not glow, repair open in Black wire from power mirror switch connector to convenience center connector. If test light glows, check for open in Red wire between each power mirror and power mirror switch. If circuit is okay, replace power mirror switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.