Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1996SPORTVAN VAN PASSENGER EXTENDED, 6.5 YREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 8 (ENGINE CONTROLS - ADJUSTMENTS - 3.1L)IGNITION TIMING3.1L WITH DISTRIBUTOR
1996 Chevrolet Sportvan Van Passenger Extended, 6.5 Y
3.1L With Distributor
1996 Chevrolet Sportvan Van Passenger Extended, 6.5 YSECTION 3.1L With Distributor
WARNING: This page is about a different car, the 1995 Pontiac Trans Sport and 1995 Chevrolet Lumina APV. However, it is still accessible from the selected car via links, so may be relevant.
- Set parking brake, block drive wheels and place transmission in Neutral or Park. Warm engine to normal operating temperature. Turn A/C off (if equipped). Ensure Malfunction Indicator Light (MIL) is off.
- Disconnect Tan/Black Electronic Spark Timing (EST) by-pass connector wire. On 4.3L, by-pass connector is on wiring harness conduit near distributor. On other models, by-pass connector is located near heater housing in passenger compartment. On all models, DO NOT disconnect 4-wire connector at distributor.
- Connect timing light to No. 1 spark plug wire. Check timing and adjust if necessary. See V6 IGNITION TIMING table. Reconnect EST by-pass connector. Clear Diagnostic Trouble Code (DTC).
IGNITION TIMING
| Application | Man. Trans. | Auto. Trans. |
|---|---|---|
| 3.1L | 10 @ Idle | 10 @ Idle |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.