Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1996SPORTVAN VAN PASSENGER EXTENDED, 6.5 YREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 51 (ENGINE CONTROLS - TESTS W/CODES - 7.4L)TROUBLE CODE CHARTSCODE 13, OPEN OXYGEN SENSOR CIRCUITDIAGNOSTIC AIDS
1996 Chevrolet Sportvan Van Passenger Extended, 6.5 Y
Diagnostic Aids
1996 Chevrolet Sportvan Van Passenger Extended, 6.5 YSECTION Diagnostic Aids
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 1995 GMC Vandura Special, 1995 GMC Vandura, 1995 GMC Suburban, 1995 GMC Rally Camper Special, and 1995 GMC Rally. However, it is still accessible from the selected car via links, so may be relevant.
Verify a clean, tight connection for sensor ground. An open circuit at sensor signal terminal or ground terminal will result in a Code 13.
CODE 13 TERMINAL & CIRCUIT WIRING IDENTIFICATION
| Engine Application | ECM/PCM Terminal | Wire Color | ||
|---|---|---|---|---|
| "C" & "K" Series | ||||
| 7.4L | ||||
| Oxygen Sensor Signal | A10 | Purple | ||
| Oxygen Sensor Ground | A12 | Tan | ||
| "G" Series | ||||
| 7.4L A/T | ||||
| Oxygen Sensor Signal | A10 | Purple | ||
| Oxygen Sensor Ground | A12 | Tan | ||
| "P" Series | ||||
| 7.4L A/T | ||||
| Oxygen Sensor Signal | A10 | Purple | ||
| Oxygen Sensor Ground | A12 | Tan | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.