Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1996SPORTVAN VAN PASSENGER EXTENDED, 6.5 YREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 48 (ENGINE CONTROLS - SYSTEM/COMPONENT TESTS - 7.4L)FUEL SYSTEMIDLE CONTROL SYSTEMIDLE AIR CONTROL (IAC) VALVE
1996 Chevrolet Sportvan Van Passenger Extended, 6.5 Y
Idle Air Control (IAC) Valve
1996 Chevrolet Sportvan Van Passenger Extended, 6.5 YSECTION Idle Air Control (IAC) Valve
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 1995 GMC Vandura Special, 1995 GMC Vandura, 1995 GMC Suburban, 1995 GMC Rally Camper Special, and 1995 GMC Rally. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect harness connector to motor. Check resistance across IAC coil terminals "A" to "B" and "C" to "D". See Fig 1. Resistance should be 40-80 ohms. If okay, go to next step. If resistance is not as specified, replace IAC valve.
- Check resistance between IAC terminals "B" to "C" and "A" to "D". Resistance should be infinite. If resistance is not as specified, replace IAC valve.
NOTE:
Functional testing of Idle Air Control (IAC) valve requires a scan tester capable of cycling ECM/PCM/VCM output devices (bidirectional) or a special IAC Driver and Noid Light Set (222L or J-37027). Flow charts in TESTS W/CODES - 7.4L
article may refer to Tech 1 tester, General Motors' bidirectional tester.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.