Code 72, VSS Circuit Loss Trans Output Signal - All Models: Notes

1996 Chevrolet Sportvan Van Passenger Extended, 6.5 YSECTION Notes
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 1996 Chevrolet Chevy Van, 1995 GMC Vandura Special, 1995 GMC Vandura, 1995 GMC Sonoma, and 1995 GMC Safari. However, it is still accessible from the selected car via links, so may be relevant.

VSS output sensor is a magnetic induction type. Gear teeth pressed on outside diameter of output carrier assembly induce an alternating current in sensor when drive wheels are turning.

NOTE: Test numbers refer to test numbers on diagnostic chart.
  1. Test verifies VSS voltage at control module.
  2. Test checks VSS buffer ground circuit.
  3. Test checks VSS circuit at buffer module.
  4. Test verifies VSS signal at sensor.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.