Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Code 23, Intake Air Temperature Low: Notes
Control module supplies and monitors a voltage signal (4-6 volts) to sensor. When temperatures are low, sensor resistance is high and control module will see a high-monitored voltage signal. As temperature increases, sensor resistance decreases and voltage sensed by control module drops.
- This checks if Code 23 is a hard failure or an intermittent condition.
- This simulates conditions for a Code 25. If scan tester displays a high temperature, control module and wiring are not at fault.
- This checks for continuity of sensor signal and ground circuits.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.