Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1996PICKUP C2500, 2D PICKUP, 6.5 F, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 43 (COMPUTER RELEARN PROCEDURES)RELEARN PROCEDURESTHEFT ALARM RELEARN PROCEDURE
1996 Chevrolet Pickup C2500, 2D Pickup, 6.5 F, Automatic
Theft Alarm Relearn Procedure
1996 Chevrolet Pickup C2500, 2D Pickup, 6.5 F, AutomaticSECTION Theft Alarm Relearn Procedure
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 1995 Plymouth Voyager, 1995 Plymouth Grand Voyager, 1995 Jeep Wrangler, 1995 Jeep Grand Cherokee, and 1995 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Theft alarm relearn is necessary whenever battery is disconnected or dead battery is boosted. If battery is connected or boosted without conducting relearn procedure, alarm system will enter power-up mode and vehicle will not start.
- Before reconnecting battery or connecting booster, insert door key into driver side door lock. Connect battery cable(s) and cycle driver side door lock once. Vehicle may now be started. On some models, horn will sound 3 times to indicate theft system is activated.
NOTE:
If Single Board Engine Controller or Powertrain Control Module (SBEC or PCM) is replaced, theft alarm system will not operate for minimum of 20 engine starts.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.