SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1996CORVETTE BASE, 2D COUPE, 5.7 PREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSMISSION OVERHAUL & TESTING - 4L60-ETRANSMISSION REASSEMBLY2-4 BAND & SERVO ASSEMBLY
1996 Chevrolet Corvette Base, 2D Coupe, 5.7 P

2-4 Band & Servo Assembly

1996 Chevrolet Corvette Base, 2D Coupe, 5.7 PSECTION 2-4 Band & Servo Assembly
  1. Install 2-4 band in case. Align band anchor pin end with case pin hole. Install band anchor pin in case. Ensure band anchor pin aligns with end of 2-4 band.
  2. Install 2-4 servo assembly into case, and index apply pin on band end. Check for proper engagement of apply pin on band end. Recheck 2-4 servo apply pin selection to ensure correct pin is installed. See CHECKING SERVO PIN LENGTH  under TRANSMISSION DISASSEMBLY.
  3. Different length servo pins are available. See SERVO PIN SPECIFICATIONS . Select proper length servo pin. Install servo cover and "O" ring. Compress cover and install cover retaining ring. Index ring ends with slot in case.
SERVO PIN SPECIFICATIONS

Pin ID Pin Length In. (mm)
1 Groove 2.59-2.60 (65.8-66.1)
2 Grooves 2.65-2.66 (67.2-67.5)
No Groove 2.70-2.71 (68.6-68.9)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.