Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC Will Set
With DRIVER 36 VLR and PASSENGER 36 VLR power supplies in a discharged state, DERM detects IGNITION 1 voltage at DRIVER SOURCE SENSE terminal No. A5 while simultaneously DERM does not detect IGNITION 1 voltage at PASSENGER SOURCE SENSE terminal No. A6. This test is run once each ignition cycle during Turn ON tests while 36 VLR delay is active.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.