Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1996CORVETTE BASE, 2D COUPE, 5.7 PREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSPOWER WINDOW SYSTEMTESTINGWINDOWS DO NOT OPERATE
1996 Chevrolet Corvette Base, 2D Coupe, 5.7 P
Windows Do Not Operate
1996 Chevrolet Corvette Base, 2D Coupe, 5.7 PSECTION Windows Do Not Operate
- Disconnect left window switch connector. Connect test light between ground and Yellow wire terminal at left window switch connector. Turn ignition switch to RUN position. If test light is on, go to step 3). If test light is off, repair open or short to ground in Yellow wire between left window switch and power window 30-amp circuit breaker.
- Ensure circuit breaker is okay. If wire and circuit breaker are okay, check ignition fuses No. 6 and No. 7 (60-amp), located in underhood fuse block, and wiring to Delayed Accessory Bus (DAB) relay (5-pin Black connector) for open circuit. Relay is located behind left side of instrument panel, near steering column.
- Connect test light between Yellow wire and Black wire terminals at left window switch connector. If test light is on, replace left window switch. If test light is off, check for poor ground connection. If ground connection is okay, repair open in Black wire between left window switch and ground connection.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.