Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1996CORVETTE BASE, 2D COUPE, 5.7 PREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSPOWER WINDOW SYSTEMTESTINGRIGHT FRONT WINDOW DOES NOT OPERATE
1996 Chevrolet Corvette Base, 2D Coupe, 5.7 P
Right Front Window Does Not Operate
1996 Chevrolet Corvette Base, 2D Coupe, 5.7 PSECTION Right Front Window Does Not Operate
NOTE:
If right window operates using master switch (left switch) and right window switch is inoperative, replace right window switch. If right window operates using right window switch and master switch (left switch) is inoperative, replace master switch (left switch).
- Disconnect right window switch 3-pin Black connector. Turn ignition switch to RUN position. Connect test light between ground and Tan wire terminal, then between ground and Light Blue wire terminal at right window switch connector. If test light is on, go to next step. If test light is off, repair open in Tan wire or Light Blue wire between left window switch and right window switch. If wires are okay, replace left window switch.
- Connect test light between Brown wire and Dark Blue wire at right window switch connector. Press left window switch to up and down positions. If test light is on, go to next step. If test light is off, replace left window switch.
- Reconnect right window switch connector. Disconnect right window motor connector. Connect test light between ground and Brown wire terminal, then between ground and Dark Blue wire terminal, at right window motor connector. If test light is on, go to next step. If test light is off, repair open in Brown wire or Light Blue wire between right window switch and right window motor. If wires are okay, replace right window switch.
- Connect test light between Brown wire and Light Blue wire terminals at right window motor connector. Press right window switch to up and down positions. If test light is on, replace right window motor. If test light is off, connect test light between Dark Blue wire and Black wire terminals at right window switch connector. If test light is on, replace right window switch. If test light is off, repair open in Black wire between right window switch and ground connection.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.