Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Clearing DTCS
To clear codes, ground terminal No. 12 (Dark Blue/White wire) of Data Link Connector (DLC). Turn ignition switch to ON position. Press TRIP/ODO (next test) button on DIC until "1.7" displays on trip monitor. Press ENG/MET (next value) button and hold until "--" is displayed on speedometer. CCM DTCs should now be cleared. Check if DTCs reset. Remove ground from DLC.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.