Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1996CHEVY VAN G30, VAN CARGO EXTENDED, 6.5 YREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - SYSTEM/COMPONENT TESTS - 6.5LIGNITION SYSTEMTIMING CONTROL SYSTEMS (C-4 & C-5)C-5, KNOCK SENSOR CIRCUIT (MODELS USING EXTERNAL SPARK CONTROLLER MODULE)
1996 Chevrolet Chevy Van G30, Van Cargo Extended, 6.5 Y
C-5, Knock Sensor Circuit (Models Using External Spark Controller Module)
1996 Chevrolet Chevy Van G30, Van Cargo Extended, 6.5 YSECTION C-5, Knock Sensor Circuit (Models Using External Spark Controller Module)
- An open or short circuit on ESC wire to ECM/PCM/VCM will cause a loss of 12-volt ESC controller signal. This will cause ECM/PCM/VCM to fully retard ignition timing.
- If a scan tester is available, connect tester to Data Link Connector (DLC). Using a metal object, tap on engine next to knock sensor and note knock parameter. Knock should be indicated on scan tester.
- If a scan tester is not available, backprobe ECM/PCM/VCM knock sensor signal terminal with a DVOM. With engine idling, 8-12 volts should be present at this terminal. Using a metal object, tap on engine close to knock sensor. Voltage signal at ECM/PCM/VCM terminal should drop to zero volts, and return when knock signal ceases.
- If signal does not respond as described, check knock sensor-to-controller-signal. On vehicles equipped with automatic transmission, it may be necessary to place transmission in Drive for timing change to occur. See KNOCK SENSOR under ENGINE SENSORS & SWITCHES.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.