Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1996CHEVY VAN G30, VAN CARGO EXTENDED, 6.5 YREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEMREMOVAL & INSTALLATIONVEHICLE SPEED SENSORREMOVAL & INSTALLATION (EXCEPT 4L80-E TRANSMISSION)
1996 Chevrolet Chevy Van G30, Van Cargo Extended, 6.5 Y
Removal & Installation (Except 4L80-E Transmission)
1996 Chevrolet Chevy Van G30, Van Cargo Extended, 6.5 YSECTION Removal & Installation (Except 4L80-E Transmission)
- Vehicle Speed Sensor (VSS) is located in left rear of transmission. Ensure ignition is off. Raise and support vehicle. Disconnect VSS electrical connector. Place a container under VSS mounting area to catch transmission fluid when VSS is removed.
- Remove VSS mounting bolt. Using J-38417, remove VSS and"O" ring. To install, coat NEW "O" ring with transmission fluid. Install "O" ring onto VSS. Install VSS and "O" ring into transmission using J-38417. Install mounting bolt through VSS bracket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.