Torque Specifications

1996 Chevrolet Camaro RS, 2D Convertible, StandardSECTION Torque Specifications
TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Column Bracket-To-Instrument Panel Stud Nuts 20 (27)
Column Bracket-To-Upper Support Bolts 20 (27)
Flexible Coupling Nuts 20 (27)
Intermediate Shaft-To-Steering Shaft Bolt 35 (47)
Lower Intermediate Shaft-To-Steering Gear Box Bolt 35 (47)
Steering Wheel Nut 30 (41)
Steering Wheel Rotation Sensor 40 (54)
Upper Intermediate Shaft-To-Steering Column Bolt 40 (54)
INCH Lbs. (N.m)Β 
Air Bag Module Screws 25 (2.8)
Dimmer Switch Nut & Stud 35 (4)
Ignition Switch Screw & Stud 35 (4)
Lock Cylinder Screws 22 (2.5)
Lock Housing Cover Screws 80 (9)
Support-To-Jacket Screws (1) 77 (8.8)
Turn Signal Switch Screws 30 (3.4)
(1) Steering column upper support assembly-to-column jacket assembly mounting screws.
Fig 1: Exploded View Of Steering Column Assembly
G94C33078Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.