Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1995SPORTVAN G20, 6.5 PREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 7 (ENGINE CONTROLS - ADJUSTMENTS - 7.4L)IGNITION TIMING
1995 Chevrolet Sportvan G20, 6.5 P
Ignition Timing
1995 Chevrolet Sportvan G20, 6.5 PSECTION Ignition Timing
WARNING: This page is about a different variant/trim than selected.
- Set parking brake. Block drive wheels. Place transmission in Neutral or Park. Warm engine to operating temperature. Turn A/C off (if equipped). Ensure Malfunction Indicator Light (MIL) is not on.
- Disconnect Tan/Black Electronic Spark Timing (EST) by-pass connector wire located near distributor, or in cab under glove box. DO NOT disconnect 4-wire connector at distributor.
- Connect timing light to No. 1 spark plug wire. Check timing and adjust if necessary. See IGNITION TIMING . Reconnect EST by-pass connector. Clear DTC.
IGNITION TIMING (DEGREES BTDC @ RPM)
| Application | Man. Trans. | Auto. Trans. |
|---|---|---|
| 7.4L (VIN N) | 4 @ Idle | 4 @ Idle |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.