Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1995SPORTVAN G20, 6.5 PREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 16 (ENGINE CONTROLS - REMOVE/INSTALL/OVERHAUL - 4.3L)THROTTLE POSITION (TP) SENSORREMOVAL & INSTALLATION
1995 Chevrolet Sportvan G20, 6.5 P
Removal & Installation
1995 Chevrolet Sportvan G20, 6.5 PSECTION Removal & Installation
WARNING: This page is about a different variant/trim than selected.
- Remove air cleaner assembly. Disconnect electrical connector from TP sensor. Remove attaching screws, lock washers, retainers, and TP sensor.
- To install, reverse removal procedure. Adjust TP sensor to specification. See ADJUSTMENTS - 4.3L article in the ENGINE PERFORMANCE section. When replacing a TP sensor, ensure correct part number is used. Use Loctite on TP sensor attaching screws.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.