Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Disassembly & Reassembly
1995 Chevrolet Sportvan G20, 6.5 PSECTION Disassembly & Reassembly
WARNING: This page is about a different variant/trim than selected.
- Hold throttle cam lever open at 11 o'clock position. See Fig 2. Remove mounting screws and remove governor drive motor. Release spring tension from governor drive lever. No other disassembly is possible.
- If necessary, apply Special Grease (available in repair kit only) to governor mechanism. Align governor drive motor with cover plate. See Fig 3. Reattach spring to governor drive lever.
- Hold throttle cam lever open at 11 o'clock position. See Fig 2. Tilt governor drive motor slightly. Ensure governor drive lever clears cover and align mounting holes. Apply Loctite to threads and tighten mounting screws to 27 INCH lbs. (3 N.m).
- Rotate governor drive lever clockwise. Spring tension should be felt. Release lever. Governor drive lever should return to park position. If governor drive lever does not operate as described, recheck assembly procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.