Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1995SPORTVAN G20, 6.5 PREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 16 (ENGINE CONTROLS - REMOVE/INSTALL/OVERHAUL - 4.3L)FUEL SYSTEMFUEL PUMPREMOVAL & INSTALLATION (ALL MODELS)
1995 Chevrolet Sportvan G20, 6.5 P
Removal & Installation (All Models)
1995 Chevrolet Sportvan G20, 6.5 PSECTION Removal & Installation (All Models)
WARNING: This page is about a different variant/trim than selected.
- Relieve fuel system pressure. See FUEL SYSTEM PRESSURE RELIEF (CPI or TBI) under FUEL SYSTEM . Disconnect negative battery cable. Raise vehicle and remove fuel tank. Remove sender unit and pump by turning cam lock counterclockwise using Tool (J-36608 or J-24187).
- Remove fuel pump from sending unit by pulling pump up into attaching hose while pulling outward from the bottom support. DO NOT damage rubber insulator or strainer. To install, reverse removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.