Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSCHEVROLET1995SPORTVAN G20, 6.5 PREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (ENGINE CONTROLS - SPECIFICATIONS - 4.3L)CAPACITIES
1995 Chevrolet Sportvan G20, 6.5 P
Section 1 (Engine Controls - Specifications - 4.3L): Capacities
1995 Chevrolet Sportvan G20, 6.5 PSECTION Capacities
WARNING: This page is about a different variant/trim than selected.
BATTERY SPECIFICATIONS
| Application | Cold Cranking Amps @ 0Β°F (-18Β°C) | Reserve Capacity (Minutes) |
|---|---|---|
| Light Duty | 525 | 90 |
| Heavy Duty | 600 | 130 |
FLUID CAPACITIES
| Application | (1) Quantity - Qts. (L) | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Crankcase | (2) 4.5 (4.3) | ||||||||||||
| Cooling System (Includes Heater) (3) | |||||||||||||
| "C", "K", "S" & "T" Series | 12.1 (11.5) | ||||||||||||
| "G" & "P" Series | |||||||||||||
| With Rear Heater | 14.0 (13.2) | ||||||||||||
| Without Rear Heater | 11.1 (10.5) | ||||||||||||
| "M" & "L" Series | |||||||||||||
| With Rear Heater | 16.5 (15.6) | ||||||||||||
| Without Rear Heater | 13.5 (12.8) | ||||||||||||
| Automatic Transmission (Dexron-II) (4) | 5.0 (4.7) | ||||||||||||
| Manual Transmission | (5) 2.2 (2.0) | ||||||||||||
|
|||||||||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.