Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET1995SPORTVAN G20, 6.5 PREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 7 (ENGINE CONTROLS - SPECIFICATIONS - 6.5L DIESEL)CAPACITIES

1995 Chevrolet Sportvan G20, 6.5 P

Section 7 (Engine Controls - Specifications - 6.5L Diesel): Capacities

1995 Chevrolet Sportvan G20, 6.5 PSECTION Capacities

WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 1994 GMC Yukon, 1994 GMC Vandura Special, 1994 GMC Vandura, 1994 GMC Suburban, and 1994 GMC Rally Camper Special. However, it is still accessible from the selected car via links, so may be relevant.

BATTERY SPECIFICATIONS

Application

Cold Crank Amps @ 0°F (-18°C)

Reserve Capacity Minutes

6.5L (VIN P, S & Y) ⁽¹⁾

570

⁽¹⁾	Two batteries per vehicle.

FLUID CAPACITIES

Application

⁽¹⁾ Quantity - Qts. (L)

Crankcase

⁽²⁾ 7.0 (6.6)

Cooling System (Includes Heater) ⁽³⁾

27.0 (26.0)

Automatic Transmission (Dexron-II) ⁽⁴⁾

Manual Transmission

5.0 (4.7)

4-Speed

⁽⁵⁾ 4.0 (3.8)

5-Speed

⁽⁶⁾ 2.2 (2.0)

⁽¹⁾	Fluid capacities listed are approximate. Always fill to FULL mark.

⁽²⁾	Use of synthetic 10W-30 motor oil is required on Turbo models.

⁽³⁾	Add 3 qts. (2.8L) coolant for models equipped with rear heater.

⁽⁴⁾	Drain and refill capacity only. Does not include torque converter.

⁽⁵⁾

GL-4.

⁽⁶⁾	Manual Transmission Fluid (T2850).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.