Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Intake Air Temperature (IAT) Sensor
If an IAT sensor-related code is present, see the appropriate TESTS W/CODES - 2.2L article. An out-of-calibration sensor may not set a trouble code. Use following procedure to test calibration. Disconnect IAT sensor harness connector. Connect ohmmeter between sensor terminals. Sensor resistance should be as specified. See IAT SENSOR RESISTANCE . With vehicle sitting overnight, IAT sensor and coolant sensor should have close to the same resistance reading.
| Temperature °F (°C) | Resistance (Ohms) |
|---|---|
| 210 (100) | 185 |
| 160 (70) | 450 |
| 100 (38) | 1800 |
| 70 (20) | 3400 |
| 40 (4) | 7500 |
| 20 (-7) | 13,500 |
| 0 (-18) | 25,000 |
| -40 (-40) | 100,700 |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.