Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Code P0118, Coolant Temperature Sensor Temperature High "S" & "T" Series 4.3L (VIN W): Notes
Coolant sensor uses a thermistor to control signal voltage to control module. Control module applies and monitors a 5 volts to sensor. When engine coolant is cold, sensor (thermistor) resistance is high and control module will sense a high signal voltage. As engine coolant warms, sensor resistance becomes less and control module voltage drops. With Code P0118 set, control module will turn cooling fans on and use a default engine coolant temperature value based on run time. Control module will illuminate Malfunction Indicator Light (MIL).
- This step determines if conditions necessary to set code exist.
- Simulates Code P0117. If control module recognizes low voltage, control module and wiring are okay.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.