Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Code P0113, IAT Sensor Circuit High Input - "S" & "T" Series 4.3L (VIN W): Notes
Intake Air Temperature (IAT) sensor is a thermistor. Control module applies and monitors 5 volts on circuit to sensor. When air is cold, sensor resistance is high and control module will measure a high signal voltage. If air is warm, sensor resistance is low causing control module to measure low voltage. With Code P0113 set, control module will use a default value of about 63°F (17°C) for intake air temperature. Code P0113 does not illuminate Malfunction Indicator Light (MIL).
- Tech 1 may be used to diagnose this fault since control module transmits actual values when fault is present. A grounded circuit will cause Tech 1 to display a temperature of about 297°F (147°C).
- If Tech 1 displays -40° with IAT sensor disconnected, control module and wiring are okay. Replace IAT sensor.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.