Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Code P0112, IAT Sensor Circuit Low Input - "S" & "T" Series 4.3L (VIN W): Notes
Intake Air Temperature (IAT) sensor is a thermistor. Control module applies and monitors 5 volts to sensor. When air is cold, sensor resistance is high and control module will measure a high signal voltage. If air is warm, sensor resistance is low causing control module to measure low voltage.
With Code P0112 set, control module will substitute a default value for intake air temperature. Code P0112 does not illuminate Malfunction Indicator Light (MIL).
- An open sensor, wire or connection will cause Code P0112 to set. An open circuit would cause Tech 1 to display about -40°F (-40°C). This test determines if wiring and control module are okay.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.