Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Code P0108, Map Sensor CKT - "S" & "T" Series 4.3L (VIN W): Notes
Manifold Absolute Pressure (MAP) sensor responds to changes in manifold pressure (vacuum). Control module receives this information as a signal voltage that varies from 1-1.5 volts at idle to 4-4.6 volts at full throttle. If MAP sensor fails, control module will substitute a fixed MAP value and use throttle position sensor to control fuel delivery.
- Rough, unstable or incorrect idle and low manifold vacuum must be corrected before using chart.
- This simulates conditions for Code P0108. If control module recognizes change, control module and circuits are okay.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.