Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1995FORWARD CONTROL 7.4 NREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONMAINTENANCE REMINDER LIGHT (RESET PROCEDURES)TIRE PRESSURE MONITOR SYSTEM REMINDERTPMS REMINDER RESET - PROCEDURE 21USING SCAN TOOL (2003-05 MODELS)
1995 Chevrolet Forward Control 7.4 N
Using Scan Tool (2003-05 Models)
1995 Chevrolet Forward Control 7.4 NSECTION Using Scan Tool (2003-05 Models)
- Adjust all tire pressures to the recommended Psi (kPa). See vehicle's Loading Information Label for recommended tire pressure. Turn ignition ON with engine OFF.
- Install scan tool. Turn ignition ON with engine OFF.
- With scan tool, select Special Functions.
- Select TIM Reset.
- Press Reset soft key.
- LOW TIRE indicator will flash 3 times, then turn OFF.
- Clear the TPM DTC.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.