Diagnostic Aids

1995 Chevrolet Forward Control 4.3 Z, AutomaticSECTION Diagnostic Aids

Code will set if control module detects one of 2 illegal combinations. Check all connections for good contact. An intermittent may be caused by a poor connection, chaffed wire insulation or a broken wire. Monitor voltage of each terminal while moving related harness connectors. If failure is induced, voltage reading will change.

VALID PSM COMBINATION (4L60-E)

Application A B C
Park Off On Off
Reverse On On Off
Neutral Off On Off
4th Off On On
3rd Off Off On
2nd Off Off Off
1st On Off Off
Illegal On Off On
Illegal On On On
VALID PSM COMBINATION (4L80-E)

Application A B C
Park On Off On
Reverse Off Off On
Neutral On Off On
4th On Off Off
3rd On On Off
2nd On On On
1st Off On On
Illegal Off On Off
Illegal Off Off Off
Fig 1: Code 28 Schematic ("C", "K" & "P" Series) Transmission Range Pressure Switch
G95G27595
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.