Code P060, Cruise Control With Transaxle Not In Drive: Action

1995 Chevrolet Cavalier LS, 4D Sedan, 2.2 4SECTION Action
WARNING: This page is about a different car, the 1995 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.

PCM disengages cruise control.

NOTE: Test numbers refer to numbers on diagnostic chart.
  1. Checks if Code P028 or P091 are set because they can cause Code P060 to set.
  2. Checks if P/N input to PCM from transaxle range switch agrees with transaxle pressure switch. If they do, code was driver induced by shifting into Park or Neutral while cruise control was engaged. If not, check for intermittent fault.
Fig 1: Code P060 Schematic, Cruise Control With Transaxle Not In Drive
G94C33011Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.