Code P044, Rear Oxygen Sensor Lean Signal: Action

1995 Chevrolet Cavalier LS, 4D Sedan, 2.2 4SECTION Action
WARNING: This page is about a different car, the 1995 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.

PCM turns on MIL. PCM turns on canister purge solenoid if Code P042 is also set. Transaxle shift adapts maintained at current levels.

NOTE: Test numbers refer to numbers on diagnostic chart.
  1. If Code P013 is present, diagnose this code first since an oxygen sensor not ready can cause other emission related problems.
  2. If oxygen sensor is operating correctly, voltage should fluctuate at greater than 0.3 volt. A lean sensor condition will cause voltage to remain at less than 0.3 volt.
  3. If voltage measured is greater than 0.15 volt, PCM and circuit No. 1670 are okay.
Fig 1: Code P044 Schematic, Rear O2 Sensor Lean Signal
G94I32944Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.