Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1995CAVALIER LS, 4D SEDAN, 2.2 4REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 18 (AIR BAG RESTRAINT SYSTEM)
1995 Chevrolet Cavalier LS, 4D Sedan, 2.2 4
Section 18 (Air Bag Restraint System)
1995 Chevrolet Cavalier LS, 4D Sedan, 2.2 4SECTION Section 18 (Air Bag Restraint System)
WARNING: This page is about a different car, the 1995 Chevrolet Corsica and 1995 Chevrolet Beretta. However, it is still accessible from the selected car via links, so may be relevant.
- Identification
- Description & Operation
- System Operation Check
- Post-Collision Inspection
- INTERMITTENTS & Poor Connections
- Service Precautions
- Disabling & Activating Air Bag System
- Adjustments
- Disposal Procedures
- Removal & Installation
- Diagnosis & Testing
- Notes
- Self-Diagnosis
- Sir Diagnostic System Check
- Chart A - DERM Integrity Check
- Chart B - Air Bag Indicator Comes On Steady
- Chart C - Air Bag Indicator Does Not Come On
- Chart D -Air Bag Indicator Does Not Come On Steady During Crank
- DTC 14 - Arming Sensor Disconnected
- DTC 21 - Driver Initiator Circuit Resistance High
- DTC 22 - Driver Initiator Circuit Resistance Low
- DTC 23 - Driver Initiator Circuit Voltage High
- DTC 24 - Initiator Circuit Voltage Low
- DTC 25 - Driver Initiator Circuit Short To Ignition
- DTC 26 - Driver Initiator Circuit Open
- DTC 28 - Current Sink Or Source Failure
- DTC 31 - Driver Loop Energy Reserve Feed Open
- DTC 34 - Arming Sensor Ignition Feed Open
- DTC 35 - Discriminating Sensor Open Or Missing
- DTC 42 - Loop Energy Reserve Voltage Low
- DTC 43 - Driver Source Feed Low
- DTC 51 - Frontal Crash Detected
- DTC 52 - Data Area Full
- DTC 53 - DERM Driver Initiator Circuits High Resistance
- DTC 55 - DERM Incompatibility
- DTC 61 - Sir Indicator Circuit Failure
- DTC 62 - Redundant Sir Indicator Circuit Failure
- DTC 71 And/Or 75 - Internal DERM Fault
- DTC 83 - Driver Reserve Diode Shorted
- Wire Repair
- Connector Identification
- Torque Specifications
- Wiring Diagrams
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.