Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1995CAVALIER LS, 2D CONVERTIBLE, 2.2 4, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSANTI-THEFT SYSTEMTESTINGDIAGNOSTIC TROUBLE CODES (DTCS)DTC 17, PASSLOCK(R) R-CODE LEARN FAILED
1995 Chevrolet Cavalier LS, 2D Convertible, 2.2 4, Standard
DTC 17, Passlock(R) R-Code Learn Failed
1995 Chevrolet Cavalier LS, 2D Convertible, 2.2 4, StandardSECTION DTC 17, Passlock(R) R-Code Learn Failed
- Turn ignition switch to RUN position. Disconnect PASSLOCK(R) lock cylinder connector. Using DVOM, check for battery voltage between PASSLOCK(R) lock cylinder connector terminals No. 1 (White wire) and No. 2 (Black wire). If battery voltage exists, go to next step. If battery voltage does not exist, check for open or short in White or Black wire in IP harness. If White and Black wires are okay, replace IPC. See article.
- Using DVOM, measure voltage between PASSLOCK(R) lock cylinder connector terminals No. 2 (Black wire) and No. 3 (Yellow wire). If reading is about 5 volts, replace PASSLOCK(R) lock cylinder. See PASSLOCK(R) LOCK CYLINDER under REMOVAL & INSTALLATION. If reading is not about 5 volts, check for open or short in Yellow wire in IP harness. If Yellow wire is okay, replace IPC. See appropriate article.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.