Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1995CAVALIER LS, 2D CONVERTIBLE, 2.2 4, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSAXLE DIAGNOSIS - 3T40DIAGNOSTIC TESTSP0724, BRAKE SWITCH CIRCUIT HIGH INPUT (SWITCH STUCK OFF)CONDITIONS FOR SETTING DTC P0724
1995 Chevrolet Cavalier LS, 2D Convertible, 2.2 4, Standard
Conditions For Setting DTC P0724
1995 Chevrolet Cavalier LS, 2D Convertible, 2.2 4, StandardSECTION Conditions For Setting DTC P0724
DTC will set under the following conditions:
- DTC P0502 (VSS) is not present.
- Vehicle speed is more than 20 MPH for 6 seconds, then vehicle speed is between 5-20 MPH for 4 seconds, then vehicle speed is less than 5 MPH.
- Conditions must occur 7 times without a brake switch status change.
DTC P0724 will be stored in PCM history. MIL will not light when fault is set and PCM inhibits TCC engagement.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.