Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1995CAVALIER LS, 2D CONVERTIBLE, 2.2 4, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)HEATING, VENTILATION & A/C (HVAC)GENERAL SERVICINGA/C COMPRESSOR SERVICINGSANDEN SD-7H15 7-CYLINDERCLUTCH ASSEMBLYREMOVAL
1995 Chevrolet Cavalier LS, 2D Convertible, 2.2 4, Standard
Clutch Assembly: Removal
1995 Chevrolet Cavalier LS, 2D Convertible, 2.2 4, StandardSECTION Removal
- Discharge A/C system using approved refrigerant recovery/recycling equipment. Remove compressor. Drain oil from compressor, and measure amount drained.
- Using Spanner (J-37872), hold clutch and remove compressor shaft nut. Using Puller (J-37825), remove clutch plate. Remove key from compressor shaft.
- Remove pulley external snap ring. Install jaws of Puller (J-37828) in snap ring groove on pulley.
- Install puller plate on jaws. Thread 2 bolts through puller plate into jaws finger tight. Tighten pulley center bolt and remove pulley from compressor. Remove clutch coil snap ring and clutch coil.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.