Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1995CAVALIER LS, 2D CONVERTIBLE, 2.2 4, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)DRIVELINES & AXLESAXLE SHAFTS - FRONTREMOVAL & INSTALLATIONINTERMEDIATE SHAFTREMOVAL & INSTALLATION
1995 Chevrolet Cavalier LS, 2D Convertible, 2.2 4, Standard
Removal & Installation
1995 Chevrolet Cavalier LS, 2D Convertible, 2.2 4, StandardSECTION Removal & Installation
- Install Engine Support (J-28467-A ), and support engine. Raise and support vehicle. Remove right FWD axle shaft from vehicle. See FWD AXLE SHAFTS .
- Remove stabilizer shaft from right control arm. Disconnect right lower ball joint from knuckle. Remove rear engine mount through-bolt. Remove right axle shaft. Remove intermediate shaft bracket-to-engine bolts. Remove intermediate shaft. To install, reverse removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.