Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Speed Density
On models equipped with MAP and IAT sensors, the speed density method is used to compute the airflow rate. Manifold pressure and temperature are used to calculate the airflow rate to the PCM. The MAP sensor responds to manifold vacuum changes due to engine load and speed changes.
The PCM sends a voltage signal to MAP sensor. Manifold pressure changes result in resistance changes in MAP sensor. By monitoring MAP sensor output voltage, PCM determines manifold pressure. If MAP sensor fails, PCM will supply a fixed MAP value and use the TP sensor to control fuel.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.