Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1995CAMARO BASE, 2D COUPE, 3.8 KREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSWIPER SYSTEM AND WASHER SYSTEMADJUSTMENTSWIPER ARMS
1995 Chevrolet Camaro Base, 2D Coupe, 3.8 K
Wiper Arms
1995 Chevrolet Camaro Base, 2D Coupe, 3.8 KSECTION Wiper Arms
- Operate wipers at lowest DELAY setting, then shut off wipers when arms are at inner wipe position (at bottom of sweep). Distance between right tip of wiper blade and upper edge of windshield molding should be as follows:
- Right Blade - 3.50-4.50" (89-114 mm)
- Left Blade - 3.75-5.00" (95-127 mm).
- While wipers are operating, wiping pattern of right blade should overlap wiping pattern of left blade. If wiper arms are not positioned as specified, remove and reposition wiper arms. Tighten wiper arm nuts to specification. See TORQUE SPECIFICATIONS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.