Ground Circuits

1995 Chevrolet Blazer 4D Utility, AWDSECTION Ground Circuits
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1995 GMC Vandura, 1995 GMC Rally, 1995 GMC Pickup, 1995 Chevrolet Sportvan, and 1995 Chevrolet Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using an ohmmeter, check for continuity to ground on ECM/PCM/VCM ground terminals. Resistance should be zero ohms. If not, repair open to ground.
  2. Using a DVOM, touch negative lead of voltmeter to a good ground. Touch positive lead of voltmeter to each ground terminal. With vehicle running, voltmeter should indicate less than one volt. If voltmeter reading is greater than one volt, check for open, corrosion or loose connection on ground circuit.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.