Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1995BLAZER 4D UTILITY, AWDREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROLS - TESTS W/CODES - 4.3LSELF-DIAGNOSTIC SYSTEMDIAGNOSTIC PROCEDURE
1995 Chevrolet Blazer 4D Utility, AWD
Diagnostic Procedure
1995 Chevrolet Blazer 4D Utility, AWDSECTION Diagnostic Procedure
Diagnosis of the computerized engine control system should be performed in the following order:
- Ensure all engine systems not related to the computer are operating properly. DO NOT proceed with testing unless all other problems have been repaired. Perform diagnostic circuit check before using trouble code charts. See BASIC TESTING - 4.3L article.
- If trouble codes were displayed (other than Code 12), determine whether codes are hard or intermittent. Hard codes may cause Malfunction Indicator Light (MIL) to illuminate continuously with engine running. For diagnosing hard codes, proceed to appropriate trouble code chart. For diagnosing intermittent codes, use DIAGNOSTIC AIDS in appropriate code chart or proceed to INTERMITTENTS in TESTS W/O CODES - GASOLINE article.
- If trouble codes were not displayed and a driveability problem exists, refer to SYMPTOMS in TESTS W/O CODES - GASOLINE article in this section. From there you will be sent to SYSTEM/COMPONENT TESTS - 4.3L article.
- After repairs are made, clear trouble codes and perform FIELD SERVICE MODE CHECK in BASIC TESTING - 4.3L article.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.