Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1995BLAZER 4D UTILITY, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)HEATING, VENTILATION & A/C (HVAC)HVAC CONTROL SYSTEMSA/C SYSTEM DIAGNOSIS - MANUALTROUBLE SHOOTINGBLOWER MOTOR DOES NOT OPERATE IN HIGH SPEED
1995 Chevrolet Blazer 4D Utility, AWD
Blower Motor Does Not Operate In High Speed
1995 Chevrolet Blazer 4D Utility, AWDSECTION Blower Motor Does Not Operate In High Speed
- Turn ignition switch to RUN position. Place mode selector in VENT position. Place blower switch in HIGH position. Connect test light from Orange wire at blower motor relay connector to ground. If test light glows, go to next step. If test light does not glow, check for poor connection at blower switch connector. If connection is okay, replace blower switch.
- Connect test light from Red wire at blower motor relay connector to ground. If test light does not glow, repair open Red wire between blower motor relay connector and battery junction block. If test light glows, check for poor connection at blower motor relay connector or open Black wire between blower motor relay connector and ground. If connection and wire are okay, replace blower motor relay.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.